Canon HV10 Instruction Manual page 29

- - - - - - --e • •••
Playback
Stop the playback before using this
function.
C!l~OT~ ~
[!]
• Recordings shorter than 1 minute per datel
time zone cannot be located with this function.
• Date search may not function if the date, time
or data code are not correctly displayed.
• If there are sections recorded in different
standards (HDV/DV) on the same tape, the date
search may not work correctly.
Viewing Still Images
(OJ 10)
Press
[END SEARCH) .
• "END SEARCH" appears.
• The camcorder rewindslfast forwards
the tape, plays back the last few seconds
of the recording and stops the tape.
• To cancel the search press
[END SEARCH
I
again.
CD
NOTES
• End search cannot be used once you remove
the cassette.
• If there are blank sections between
recordings, or sections recorded in different
standards (HDV/DV) on the same tape, the end
search may not work correctly.
-
O J
r:u
tJ)
n·
."
c:
:::s
(')
r+
o·
:::S'
tJ)
Locating Scenes by Recording Date
You can locate the change of the datel
time zone with the date search function.
Press
~
or
~
on the wireless
controller.
• Press more than once to search for
further date changes (up to 10 times).
• To cancel the search press (STOP.).
1
Holding the lock button pressed
down, set the POWER switch to
PLAY.
2
Move the ~/~ switch to ~
(memory card).
3
Press
[±J
or
G
to move between the
images.
IMAGE JUMP
You can jump ahead to a specific image
without having to browse all images one
by one.
Press [±JIB and hold it pressed down.
Release the button when the image
number gets to the image you want to
display.