Specifications - Sony LBT-XGV11AV Operating Instructions Manual

Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Be
sure to clean the tape heads before you start an
important recording or after playing an old tape. Use a
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetising the tape heads
Demagnetise the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetising cassette. For
details, refer to the instructions of the demagnetising
cassette.
GB
46
Break off the
cassette tab

Specifications

Amplifier section
Front speaker:
The following measured at AC 120, 220, 240 V 50 Hz
DIN power output (rated): 150 + 150 watts
Continuous RMS power output (reference):
Center speaker:
DIN power output (rated): 35 watts
Continuous RMS power output (reference):
Surround speaker:
DIN power output (rated): 35 + 35 watts
Continuous RMS power output (reference):
Inputs
PHONO IN (phono jacks): sensitivity 3 mV,
MIC-1/MIC-2 (phone jacks):
GAME INPUT AUDIO (phono jacks):
GAME INPUT VIDEO (phono jack):
MD (VIDEO) IN (phono jacks):
DVD INPUT
FRONT, REAR, CENTER, WOOFER (phono jacks):
DVD VIDEO INPUT (phono jack):
(6 ohms at 1 kHz, DIN)
200 + 200 watts
(6 ohms at 1 kHz, 10%
THD)
(8 ohms at 1 kHz, DIN)
50 watts
(8 ohms at 1 kHz, 10%
THD)
(8 ohms at 1 kHz, DIN)
50 + 50 watts
(8 ohms at 1 kHz, 10%
THD)
impedance 47 kilohms
sensitivity 1 mV,
impedance 10 kilohms
sensitivity 250 mV,
impedance 47 kilohms
1Vp-p, 75 ohms
sensitivity 450 mV
(250 mV), impedance
47 kilohms
sensitivity 450 mV,
impedance 47 kilohms
1Vp-p, 75 ohms