Table of Contents
Advertisement
Other operations
To
Do this
1
Check the setting
Press TIMER SELECT (or
CLOCK/TIMER SELECT
on the remote).
2
Press M/m repeatedly until
“REC SELECT” appears,
then press ENTER.
Change the setting
Start over from step 1.
1
Cancel the timer
Press TIMER SELECT (or
CLOCK/TIMER SELECT
on the remote).
2
Press M/m repeatedly until
“TIMER OFF” appears, then
press ENTER.
Notes
• You cannot activate the Daily Timer and Timer
Recording at the same time.
• If you use the Timer Recording and Sleep Timer at
the same time, the Sleep Timer has priority.
• If the system is on at the preset time, the Timer
Recording will not be activated.
• The volume is reduced to minimum when Timer
Recording starts.
Tip
The system turns on 15 seconds before the preset time.
Display
Turning off the display
— Power Saving Mode
The demonstration display (display window and
buttons lighting and flashing even when the
system power is off) and the clock display can
be turned off to minimize the amount of power
consumed during standby (Power Saving
Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display and the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
cyclically as follows:
Demonstration display t Clock display* t
No display (Power Saving Mode)
* “– –:– –” is displayed if you do not set the clock.
Note
You cannot perform the following operations in Power
Saving Mode.
– setting the clock (page 11)
– changing the AM tuning interval (page 20)
– turning on the system by pressing the function
buttons (e.g., CD: NX (or CD N on the remote))
– changing the CD power manage function (page 20)
– switching the MD (VIDEO) function (page 39)
– changing the color system (page 8)
Tip
The timer continues to operate in Power Saving Mode.
GB
Page 33
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
