Table of Contents
Advertisement
3 Connect the surround speakers.
Connect the speaker cords to the
SURROUND SPEAKER jacks as shown
below.
Insert only the stripped portion
Gray (3)
Black (#)
4 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
Extend the FM lead
antenna horizontally
AM loop antenna
C O
A X I
A L
F M
7 5
Note
Keep the antennas away from the speaker cords.
5 Connect the video input jack of your TV
to the VIDEO OUT jack with the
supplied video cord.
When using a TV
Turn on the TV and select the video input so you can
view the pictures from this system.
GB
6 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
Refer to the print on your system’s
VOLTAGE SELECTOR for available
settings.
VOLTAGE SELECTOR
120V
220V
230 ~ 240V
7 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
You can cancel the demonstration by
pressing DISPLAY repeatedly (page 33).
8 Set the color system to PAL or NTSC
depending on the color system of your
TV while the power is off.
The color system is factory set to AUTO.
The color system
Do this
of your TV
Press ?/1 while holding
NTSC
down MOVIE. The system
is set to NTSC.
Press ?/1 while holding
PAL
down REGGAE. The
system is set to PAL.
Press ?/1 while holding
AUTO
down TANGO. If your TV
automatically changes the
color system according to
the input signal, the system
is set to AUTO.
Notes
• You cannot set the color system in Power Saving
Mode (page 33).
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
unit, the picture image may be distorted.
Page 8
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
