D-Link DAP-3520 Command Line Interface Reference Manual page 35

If a TFTP server is being used to get the configuration file from a PC, to get firmware from a PC, or to put a configuration file on a PC, see the examples below. Please
note that users must enable the TFTP server on the PC before using these commands.
The following is an example of using TFTP to get a configuration file from a PC, using the format tftp getconfig [config file name] [host IP address].
The following is an example of using TFTP to put a configuration file on a PC, using the format tftp putconfig [config file name] [host IP address].
The following is an example of using TFTP to get firmware from a PC, using the format tftp getfirmware [firmware file name] [host IP address].
AirPremier N Dual Band PoE Access Point Command Line Interface Manual
WAP-> tftp getconfig dap3520.dcf 1.49.12.1
tftp: Update configuration file successfully!
WAP-> tftp putconfig dap3520.dcf 1.49.12.1
tftp: Put configuration file successfully!
WAP-> tftp getfirmware dap3520-firmware-v100-r0018.bin 1.49.12.1
head in flash
Burning done!
32