Gap/Black Mark Calibration, Self-Test And Dump Mode - Max Meyer LabelMax SP2 User Manual

4.2 Gap/Black Mark Calibration,
While calibrate the gap/black mark sensor, printer will measure the label length, print
the internal configuration (self-test) on label and then enter the dump mode. To
calibrate gap or black mark sensor depends on the sensor setting in the last print job.
Please follow the steps below to calibrate the sensor.
1. Turn off the power switch.
2. Hold on the button while turning on the power switch.
3. Release the button when LED becomes amber and blinking. (Any amber will
do during the 5 blinks).
The LED color will be changed as following order.
Amber red (5 blinks)
blinks) red/amber (5 blinks)
4. It calibrates the sensor and measures the label length and prints internal settings
then enter the dump mode.
Self-test and Dump Mode
amber (5 blinks) green (5 blinks)
solid green
green/amber (5
13