Arctic Cat 450 H1 2010 Operator's Manual page 59

2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
 NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer, distance, and
time.
 NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two sec-
onds after the Mode Button is
released, the digital gauge will
return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and
resets various displays on the digi-
tal gauge. Also used to shift from
speedometer function to tachome-
ter function on the speedometer/
tachometer gauge.
5. Odometer/Trip Meter (T1 and T2)
- Odometer registers the total dis-
tance the vehicle has traveled. Trip
meters can register two distances
(for instance, T1 could register trip
distance and T2 could register dis-
tance between stops). The trip
meters can be reset while the
odometer only registers accumu-
lated miles/kilometers and the
odometer cannot be reset to zero.
All distances correspond to speedome-
ter function selected (MPH or km/h).
 NOTE: To select the odometer
(ODO), trip #1 (T1), or trip #2 (T2),
press the Mode Button (3) to select
the distance mode; then press the
Set/Reset Button (4) to select the
desired display. Hold the Set/Reset
button down to reset trip meters.
6. Gear Position Indicator - Indicates
which gear position is selected.
• R (reverse)/N (neutral)/ L (low
range)/ H (high range).
 NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
7. Speedometer/Tachometer - A nee-
dle indicates approximate vehicle
speed in mph or km/h when speed-
ometer function is selected or rpm
when tachometer
selected.
8. Needle Indicator Display - Dis-
plays which speedometer function
(MPH or km/h) or tachometer
function (RPM) is selected.
 NOTE: The speedometer and
tachometer functions
switched by pressing the Set/
Reset Button.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD
lock is engaged. The display is
blank when in 2WD.
11. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
function is
may be
CF101A
57