Table of Contents
Advertisement
Note: A full dispenser should last approximately one month.
If you want to adjust the amount of rinse agent dispensed, the
dispenser has 1 to 6 levels that you can adjust to. Simply rotate the dial
to your desire settings.
Checking Water Temperature
• Your incoming water must be between at least 120°F / 49°C and at
most 151°F / 66°C in order to clean effectively and prevent damage to
your dishware.
Note: The minimum incoming temperature must be at 120°F/49°C in
order for the detergent to dissolve properly.
If you are unsure of the temperature of your hot water:
1. Simply open the hot water faucet and let it run for a minute and fill a
glass.
2. Take a thermometer and check the temperature of the water.
3. If the temperature is below 120°F / 49°C, then you need to adjust
the water temperature on your water heater in order to maintain that
temperature level.
Overflowing Protection:
• In case the water level is rising above the highest acceptable point,
the security pressure switch will activate the drain pump automatically.
The Filtration System
For your convenience, the three level filtration system is conveniently
located inside the dishwasher tub beneath the lower rack and consists of
a Main Filter, Coarse Filter and Fine Filter.
19
Advertisement
Table of Contents
