Sinarcam Installation Instruction; Hardware Installation; Software Installation - Sinarcam Multipurpose Digital Camera User Manual

Sinarcam Installation Instruction

1. Hardware Installation

• Connect the serial cable to the modem or printer
port of the Macintosh computer and to the Sinar
power supply.
• Connect the Sinarcam cable (4 m long) to the Sinar
power supply.
• Connect the synchro cord to the Sinar power
supply.
• Connect the Leaf DCB LV to the Macintosh
computer (see Leaf installation manual)
• Turn on the Sinar power supply and the Macintosh
computer.

2 Software Installation

• Insert the Sinarcam floppy disk in your
Macintosh computer and double click the
Sinarcam floppy icon.
• Double click the read-me icon to see the latest
information about the software.
• If you have a Power Macintosh computer with System Software
7.5.2 or earlier, drag the DMA-extension onto the system folder to
install the extension automatically to the right place. In this case,
you need to restart the computer. You don't need to install the
extension with System Software 7.5.3 and higher. To find out the
version of your System Software, select the menu entry "About
this Macintosh" in the Apple-menu.
• To start the Sinarcam software, double click the Sinarcam icon.
• During startup of the software, you have
a chance to select the serial port to which the sinarcam is
connected. The software automatically continues after some
seconds if you don' t change the serial port.
Sinarcam1UsersGuideE.rtf
Synchro cord
connector
Serial cable
connector
Sinarcam
cable
connector
Date: 14.03.00 14:22