Setup The Sinarcam As A Stand Alone Camera - Sinarcam Multipurpose Digital Camera User Manual

8. Setup the Sinarcam as a stand alone camera

To setup the stand alone sinarcam, do the following:
n
If you have the DCB deposit accessory (see figure beside), mount
the deposit on top of your studio stand or your tripod.
n
Add the DCB holder to the deposit bar and tight all screws with the
wrench that is attached at the rear of the deposit. Note that this
device will hold the DCB later when it is not attached to the
sinarcam, so make sure the DCB cannot turn the deposit and slip
out!
n
Mount the Sinarcam stand to the DCB deposit or directly on a studio
stand or tripod.
n
Mount the Sinarcam body to the Sinarcam
stand. Please protect the LCD and color
filters of the Sinarcam by always using the
front and back covers of the body when
handling the Sinarcam!
n
Add the lensboard to the sinarcam body
and attach a lens to the lensboard.
n
Finally mount the Leaf DCB to the Sinarcam body and connect
the Leaf taxi cable and the Sinarcam cable to the camera.
n
Aim the camera to your subject. Now your are ready to take
your first digital picture
Sinarcam1UsersGuideE.rtf Date: 14.03.00 14:22