Replacing Ink Cartridges - Epson Stylus Photo RX620 series Basic Operation Manual

Replacing Ink Cartridges

Note:
Before replacing an ink cartridge, read "Precautions on
Ink Cartridge Replacement" on page 28 and "When
handling ink cartridges" on page 3.
1. When the ink is empty:
Refer to the LCD panel message to see which ink
cartridge is empty, and then press the OK button.
When the ink is low:
Press the Setup button and select the Ink
cartridge.
Confirm the messages on the LCD panel and
press the OK button to start the ink cartridge
replacement.
The ink cartridges move to the replacement
position.
2. Make sure that the document cover is closed,
and then open the scanner unit.
Caution:
c
❏ Do not move the print head by hand, as
this may damage this product.
❏ Do not start replacing an ink cartridge
before the print head stops.
Cancel OK
Cancel OK
3. Open the cartridge cover.
4. Remove an ink cartridge from its package.
5. Pinch the sides of the ink cartridge that you want
to replace. Lift the cartridge out of this product
and dispose of it properly. Do not take the used
cartridge apart or try to refill it.
Warning:
w
If ink gets on your hands, wash them
thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water. If discomfort or vision problems
continue after a thorough flushing, see a
doctor immediately.
Caution:
c
Leave the used ink cartridge installed until
just before replacement; otherwise, ink
remaining in the print head nozzles may dry
out.
6. Place the replacement ink cartridge vertically
into the cartridge holder, then push the ink
cartridge down until it clicks into place.
Replacing Ink Cartridges
The illustration shows
replacement of the
black ink cartridge.
29