Uniden BC346XT User Manual page 235

<COMMAND TIN>
Get/Set TGID Info
Controller → Radio
TIN,[INDEX][\r]
TIN,[INDEX],[NAME],[TGID],[LOUT],[PRI],[ALT],[ALTL],[RSV],[RSV],
[NUMBER_TAG],[RSV],[ALT_PATTERN],[VOL_OFFSET][\r]
Radio → Controller
TIN,[NAME],[TGID],[LOUT],[PRI],[ALT],[ALTL],[REV_INDEX],[FWD_INDEX],
[SYS_INDEX],[GRP_INDEX],[RSV],[RSV], [NUMBER_TAG],[RSV],
[ALT_PATTERN],[VOL_OFFSET] [\r]
TIN,OK[\r]
[INDEX]
[NAME]
[TGID]
[LOUT]
[PRI]
[ALT]
[ALTL]
[REV_INDEX]
[FWD_INDEX]
[SYS_INDEX]
[GRP_INDEX]
[NUMBER_TAG]
[ALT_PATTERN]
[VOL_OFFSET]
Get/Set TGID Information.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
This command is only acceptable in Programming Mode.
When the system protect bit is ON, except [REV_INDEX], [FWD_INDEX], [SYS_INDEX],
[GRP_INDEX], other parameters will be send as a reserve parameter in the Radio -
> Controller command.
<COMMAND GLI>
Get Lockout TGID (for Rvw L/O ID)
Controller → Radio
GLI,[SYS_INDEX][\r]
Radio → Controller
GLI,[TGID][\r]
GLI,-1[\r]
This command is used to get L/O TGID list of a system.
You should call this command again and again to get all L/O TGID until the
scanner returns "-1".
"-1" means that no more L/O TGID exists.
When the system protect bit is ON, only "-1" will be send in the Radio ->
Controller command.
This command is only acceptable in Programming Mode.
: TGID Index
: Name (max.16char)
: TGID
: Lockout
: Priority
: Alert Tone
: Alert Tone Level
: Reverse TGID Index of the Group
: Forward TGID Index of the Group
: System Index of the TGID
: Group Index of the TGID
: Number tag
: Alert Light Pattern(0:ON / 1:SLow / 2:Fast)
: Volume Offset
: No more lockout TGID
(0:Unlocked / 1:Lockout)
(0:OFF / 1:ON)
(0:OFF / 1-9:Tone No)
(0:AUTO/ 1-15)
(0-999 / NONE)
(-3 - +3)
235