SLX 64 Element Digital TV Aerial Kit User Guid

27985K4
Congratulations on the purchase of your high gain wideband aerial kit which is designed to receive digital terrestrial signals.
This aerial is also 4G ready - the design restricts bandwidth to prevent interference & channel loss on your TV caused by signals from 4G transmitters.
This aerial has been manufactured to the standard required to get the best reception of digital terrestrial TV services (such as Freeview™). If the
aerial is to be used for DTT reception check before installation at www.dtg.org.uk/retailer/coverage.html to confirm that your home is in a coverage
area and to find out where your local transmitter is. This kit contains all the items necessary for central mounting the aerial to an existing mast or for
rear mounting externally to eaves or a wall or mounting in a loft. This kit also contains 10m of digital type coax cable to ensure good reception.
Every aerial installation is different in nature. To fit suitable brackets, fixings and poles/masts you need to take into consideration:
WARNING
a.) The state and type of surface being mounted to. b.) The weight of the assembly to be mounted. c.) The exposure to and effect of
prevailing winds. Fixings and brackets supplied with this product may not be suitable for your particular installation.
The pole mount bracket and pole supplied with this product are recommended for loft mounting only. If in doubt please consult a CAI registered installer.
Main Features
•
Wideband - suitable for all UK TV reception areas, covering UHF channels 21 to 60
•
Receives all digital TV signals on 470 - 790MHz
•
Perfect for use in the majority of locations although in very high strength signal areas an
attenuator may be required, or for very weak strength signal areas an amplifier may be needed
The aerial requires some assembly - please read these instructions carefully before beginning.
A. rotating aerial elements, central
boom and centre mount assembly
1. Rotate the elements about the central fixing clip until they
'snap' into an upright position as shown in Fig. 1.
2. The central boom comes in two sections using the bracket supplied and the
holes drilled in the boom sections join these two sections as shown in Fig. 2.
3. Attach centre mount bracket in the position shown using the clips supplied.
Fig. 1
rotate elements
B. Fitting the reflectors
1. Using the reflector clamps, screw and large wing nut, fix
the reflector assemblies to the main aerial boom see Fig. 4.
2. Check that the reflector clamp tabs locate in the holes
of the reflector boom sections and that the wing nut
is tight - see Fig. 3.
Fig. 3
reflector
clamps
64 Element Digital TV Aerial Kit
UsEr GUiDE
element
in upright
position
engage
tab
in hole
reflector
element
central boom
back section
Fig. 2
centre mount bracket
with clips, bolts and
wing nuts
Fig. 4
reflector boom
assembly
Ready
central boom
front section
joining bracket with
bolts and wing nuts