Volvo S80 Owner's Manual page 270

06 Infotainment system
Radio
– Activate/deactivate in FM mode under
FM menu Advanced settings
Alternative frequency.
Regional radio programmes – REG
This function causes the radio to continue
with a regional transmitter even if its signal
strength is low. The symbol
the function is active.
– Activate/deactivate in FM mode under
FM menu Advanced settings
Resetting RDS functions
All radio settings can be reset to the original
factory settings.
– The reset is carried out in FM mode under
FM menu Advanced settings
Reset all FM settings.
06
Volume control, programme types
The interrupting programme types, e.g.
NEWS or TP , are heard at the volume
selected for each respective programme
type. If the volume level is adjusted during the
programme interruption, the new level is
saved until the next programme interruption.
Scan wavelength
The function automatically searches for avail-
able channels and takes into account any
programme type filtering. When a station is
*
268
Option/accessory, for more information, see Introduction.
found, it is played for approx. 10 seconds
before scanning is resumed. When a station
is playing back it can be saved as a preset in
the usual way, see the section Preset, page
265.
– To start scanning go in FM/AM mode to
FM menu
REG
shows that
NOTE
Scanning stops if a station is saved.
REG.
Radio system - DAB*
General
DAB (Digital Audio Broadcasting) is a digital
broadcasting system for radio. This system
supports DAB, DAB+ and DMB.
NOTE
Coverage for DAB is not available in all
locations. If there is no coverage then the
message
display screen.
Scan or AM menu Scan.
No reception
is shown in the
Service and Ensemble
•
Service - Channel, radio channel (only
audio services are supported by the sys-
tem).
•
Ensemble - A collection of radio chan-
nels on the same frequency.
Storing channel groups (Ensemble
learn)
When the vehicle is moved to a new broad-
casting area, programming of existing chan-
nel groups in the area may be necessary.
Programming of channel groups creates an
updated list of all available channel groups.
The list is not updated automatically.
Programming is carried out in the menu sys-
tem in DAB mode under DAB menu
Ensemble learn. Programming can also take
place as follows:
1. Turn TUNE one step in either direction.
> Ensemble learn is shown in the list of
available channel groups.
2. Press OK/MENU.
> New programming is started.
Programming can be cancelled with EXIT.