What Are The Installer Settings - Lennox SignatureStat 81M26 User Manual

110-1052F 5/12/05 11:59 AM

What are the INSTALLER settings?

The INSTALLER SETTINGS are setup during the initial installation. They tell the thermostat how to function with your heating or
cooling equipment. The following is a brief overview and discussion of these settings.
INSTALLER SETTINGS
SYSTEM SETUP GAS
RESIDUAL COOL 60
LOW BALANCE 45˚F
HIGH BALANCE 95˚F
HOME
SELECT
SYSTEM SETUP
FURNACE
HEAT PUMP
INSTALL MENU
1ST STAGE HEATING
GAS / OIL
ELECTRIC
INSTALL MENU
Page 21
INSTALLER SETTINGS
AUTOCHANGEOVER
EER
*
DEADBAND
HUMIDITROL
HOME
SELECT
* DEADBAND is displayed only
when AUTOCHANGEOVER is ON.
SYSTEM SETUP
Choose the system component that the thermostat will control.
With the 81M26, either a furnace or a single-stage heat pump (with no auxiliary heat)
can be used. If FURNACE is selected, then either a GAS/OIL or ELECTRIC furnace
can be used.
SELECT
1st STAGE HEATING
With the 81M27, either a GAS/OIL or ELECTRIC furnace can be used.
SELECT
INSTALLER SETTINGS
ON SECURITY
ON
CONTACT INFO
3˚F
SERVICE INT
OFF
REMINDER
MAIN MENU
INSTALLER SETTINGS
OFF CONTACT INFO
SERVICE INT
REMINDER
RUN TEMP OFFSET
SELECT MAIN MENU
RUN
0.0°F
SELECT
21