Whirlpool Gas Range User Manual page 18

Whirlpool gas range cooker
Hide thumbs Also See for Gas Range:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
POSSIBLE CAUSES AND/OR SOLUTIONS
Oven will not operate
Oven burner flames are
yellow or noisy
Oven temperature too high
Oven temperature
needs adjustment - See "Oven Temperature Control" in the "Electronic Oven
or too low
Controls" section.
Convection
fan not
The convection
cycle is in the first 5 minutes of operation
- This is normal. The convection fan will
working
start running approximately 5 minutes into the cycle.
Oven door is open - If the oven door is opened during convention cooking, the fan will turn off
immediately. It will come back on when the oven door is closed.
Display shows messages
Clean cycle did not work
on all spills
Mineral deposits are left on
the oven bottom after the
Clean cycle
Oven cooking results not
what expected
Air in the gas lines - If this is the first time the oven has been used, turn on any one of the surface
burner knobs to release air from the gas lines.
Control is locked - Press and hold START for 3 seconds to unlock.
Control is in Demo Mode - Press and hold START TIME for 10 seconds to exit Demo Mode. Demo
Mode is used for display models in a showroom.
Electronic
oven control set incorrectly
- See "Electronic Oven Controls" section.
Range converted
improperly
- If propane gas is being used, contact a service technician or see cover
for contact information.
Power failure (display
shows flashing
time) - Clear the display. On some models, reset the clock, if
needed. See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter followed
by number) - Depending on your model, press CANCEL to
clear the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for
service. See cover for contact information.
Start needs to be pressed so a cycle can begin (display
shows "PUSH" or "PSH") - See the "Start"
keypad feature in the "Feature Guide" section.
Range is in Sabbath Mode (display shows "SAb")
- Press CANCEL to exit Sabbath Mode.
Several cooking cycles between Clean cycles or spills on oven walls and doors - Run additional
Clean cycles. Use the AquaLift ®Technology Cleaning Kit. affresh ®Kitchen and Appliance Cleaner or
affresh ® Cooktop Cleaner can be used for stubborn soils. See the "Accessories" and "Clean Cycle"
sections for more information.
Tap water was used in the Clean cycle - Use distilled or filtered water in the Clean cycle.
To remove deposits, use a cloth soaked with vinegar. Then use a cloth dampened with water to
thoroughly remove any vinegar residue.
Range is not level - Mineral deposits will collect on dry areas of the oven bottom during the Clean cycle.
Level the range. See the Installation Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use a cloth dampened with water to
thoroughly remove any vinegar residue.
Range is not level - Level the range. See the Installation Instructions.
The temperature
set was incorrect
- Double-check the recipe in a reliable cookbook.
Oven temperature
needs adjustment
- See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
Oven was not preheated
- See "Baking and Roasting" section.
Racks were positioned
improperly
- See "Positioning Racks and Bakeware" section.
Not enough air circulation
around bakeware - See "Positioning Racks and Bakeware" section.
Darker browning
of food caused by dull or dark bakeware - Lower oven temperature 25°F (15°C) or
move rack to a higher position in the oven.
Lighter browning
of food caused by shiny or light colored
bakeware - Move rack to a lower position
in the oven.
Batter distributed
unevenly
in pan - Check that batter is level in the pan.
Incorrect
length of cooking
time was used - Adjust cooking time.
Oven door was not closed - Be sure that the bakeware does not keep the door from closing.
Oven door was opened during cooking
- Oven peeking releases oven heat and can result in longer
cooking times.
Rack is too close to bake burner, making baked items too brown on bottom
- Move rack to higher
position in the oven.
Pie crusts
browning
too quickly
- Use aluminum foil to cover the edge of the crust and/or reduce
baking temperature.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents