Package Contents; Installation; Hardware Installation - LevelOne FCS-1070 User Manual

Installation

Hardware Installation

Upon powering up, the device runs through a self-test procedure and the front LEDs will blink
between green and red for a few times. If self-test passes, the LEDs will shut off and the
Network Camera will be on stand-by and ready for software installation. If self-test fails the red
LED will blink several times. Refer to Appendix A for troubleshooting.
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the Network
Camera will try WLAN. During the searching and connecting process to the wireless access
point or station, the LED of the Network Camera will keep red. Until the Network Camera is
connected to the other wireless device, the LED will become green and flash. Operating in
either network mode, the green LED will flash every second as heartbeat to indicate alive.
* This feature supports WCS-2070 only
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet cable
plug in the power adapter. If the LED turns out to be steady green after self-test, go to next
paragraph "Software Installation". If the Ethernet is not available, the Network Camera will
switch to wireless LAN mode (WCS-2070 only).
Please verify that your product package contains
all the accessories listed in the foregoing
Package Contents. Depending on the user's
application, an Ethernet cable may be needed.
The Ethernet cable should meet the specs of
UTP Category 5 and not exceed 100 meters in
length.
Connect the power adapter jack to the
Network Camera before plugging in to the power
socket. This will reduce the risk of accidental
electric shock.