Application Setup; Weekly Schedule; Event Operation - LevelOne FCS-1070 User Manual

Application Setup

Weekly Schedule

"Sun" ~ "Sat" Select the days of the week to perform the following operations.
"Snapshots begin at" Set the time to start operations.
"Snapshots stop at" Set the time to stop operations. Setting identical begin time and stop time
means 24-hour operation.
"All the time except for the above schedule" Invert the selected schedule. The default setting
of this option is checked.
"Snapshot file name prefix" Specify the prefix name for the snapshot file. Please check naming
rule of snapshot file for more detail.

Event Operation

"Delay second(s) before detecting next event" Set the time delay before restarting to check
on the triggering condition when the current condition is triggered.
"Send pre-event image(s) when event occurs" Specify how many pre-event snapshot will be
sent if events happen.
"Trigger condition" There are four conditions relative to the digital input and three windows for
motion detection. More than one condition can be selected at once. Select the appropriate
digital input condition that suits the characteristics of the external device. "high", "low" selects
level-triggering via external voltage input. "rising", "falling" is for edge-triggering. There are three
windows for motion detection each can be assigned a name. If motion detection has not been
set up, it will not be shown. If this happens, clicking on "Motion detection" and a note will show to
direct the User to the configuration page for motion detection.
"Trigger action" There are four options for two types of action. More than one condition can be
selected at once. While choosing to trigger an output alarm, the digital output will short both pins
and complete the external device's circuit. The normal state is open. Either email or FTP can be
used to command uploading snapshots. The date and time suffix may also be added as an
option. Confirm the external mail or FTP server settings in the network configuration.
"Reset output" Select and save this option to reset the external device at the digital output to
return to the original state.