Set Server Parameter Values - LevelOne FCS-1070 User Manual

<parameter pair>
where <parameter pair> is
<parameter>=<value>\r\n
[<parameter pair>]
<length> is the actual length of content.
Example: request IP address and it's response
Request:
http://192.168.0.123/cgi-bin/admin/getparam.cgi?network_ipaddress
Response:
HTTP/1.0 200 OK\r\n
Content-Type: text/html\r\n
Context-Length: 33\r\n
\r\n
network.ipaddress=192.168.0.123\r\n

Set server parameter values

Note: This request require administrator access
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/setparam.cgi? [nosync=<value>&]<parameter>=<value>
[&<parameter>=<value>...][&return=<return page>]
parameter
nosync
<group>_<name>.
return
value
0, 1
value to assigned
<return page>
description
Specifies that there should be no sync (write) of the
corresponding configuration file on flash. If parameter
is omitted, a sync write will occur.
(note: this parameter must be put at begin of
parameter list)
Assign <value> to the parameter <group>_<name>..
Redirect to the page <return page> after the parameter
is assigned. The <return page> can be a full URL path
or relative path according the the current path. If you