ATEN CS-1742 User Manual page 17

The front panel components are described in the table below:
No. Component
1. Port Selection
Switches
2. Port LEDs
3. USB Port
Press a switch to access the computer attached to its
corresponding port.
Pressing Buttons 1 and 2 simultaneously for 2 seconds
starts Auto Scan Mode. See page 15 for details.
The Port LEDs are built into the Port Selection Switches.
The upper ones are the KVM Port LEDs; the lower ones
are the USB LEDs:
KVM: Lights DIM ORANGE to indicate that the computer
attached to the corresponding port is up and running
(On Line).
Changes to BRIGHT ORANGE to indicate that the
computer attached to its corresponding port is the
one that has the KVM focus (Selected).
Flashes to indicate that the computer attached to its
corresponding port is being accessed under Auto
Scan mode.
USB: Lights DIM GREEN to indicate that there is a USB
cable connection to the computer. Does not light if
there is no USB connection to the computer (see
item 2 of the installation diagram on page 10).
Changes to BRIGHT GREEN to indicate that the
computer attached to its corresponding port is the
one that has access to the USB peripherals.
Cables from your USB peripherals (printers, scanners, etc.)
can plug in here, as well as into the USB port on the rear
panel.
Description
1. Introduction
5