Hardware Installation - Vivotek ND8401 User Manual

IMPORTANT:
For a RAID volume configuration, it is recommended you use hard drives of the same model
featuring the same capacity and rotation speed, even running the same version of firmware.

Hardware Installation

SATA hard disk(s) are user-supplied. The network video recorder can readily accommodate
most of the off-the-shelf SATA hard drives.
1. Open the front panel.
2. Use the included bezel key to unlock the bezel lock.
3. Open the drive tray bezel by flipping the bezel latch to the side. The bezel lever will spring
open, and you can then remove the drive tray.
1
2
Bezel Lock
4. Install your hard disk to the drive tray. Gently put the hard disk into drive tray with its label side
facing up and the connector side facing the inside of the chassis. Flip the hard drive and drive
tray over, and then secure the hard drive by fastening 3 screws.
Bezel Lever
Bezel Latch
VIVOTEK
2
1
User's Manual - 11