Maintenance And Inspection - Hitachi CS 36DL Safety Instructions And Instruction Manual

English
After fi ling away the depth gage, round off the
front side of the depth gage as it was. (Fig. 36)
After sharpening the saw chain, place it into
chain oil to wash off the fi lings.
If fi lings are not cleaned off , the saw chain and
guide bar will quickly wear while in use.

MAINTENANCE AND INSPECTION

After operation,
maintenance of each part when storing the unit.
WARNING
During maintenance
always switch off the unit and remove the
storage battery from the main body. In
addition, disconnect the power plug of the
charger from the outlet.
1. Inspection of saw chains
○ Occasionally inspect the saw chain. In the
event of any abnormality, replace it with a new
one referring to "Installing (replacing) saw
chain" .
○ Inspect the chain tension and check If it is
correctly tightened.
○ Stop using the unit when the saw chain
becomes blunt and sharpen it referring to
"Sharpening of the chain blade".
○ After use, carefully lubricate the saw chain and
guide bars with oil for rust-proofi ng.
CAUTION
Wear gloves to avoid injury while using a
saw chain.
2. Cleaning the side cover and brake band
chamber (Figs. 37, 38)
Clean and remove any sawdust left inside the
parts.
24
0.025" (0.635 mm)
Fig. 34
perform inspection
and inspection,
Depth gage jointer
Protruding depth gage head
and
NOTE
When cleaning the side cover, brake band
chamber, chain oil spout, and side bar, see the
procedure "Installing (replacing) saw chain"
and remove the saw chain.
3. Cleaning the chain oil spout (Fig. 39)
Before cleaning the chain oil spout, remove the
side cover and guide bar.
Flat fi le
Fig. 35
Round off
Fig. 36
Side cover
Fig. 37
Brake band
chamber
Fig. 38
Chain oil spout
Fig. 39