Connections - Sanyo VCC-4594P Instruction Manual

CONNECTIONS

(Video signal connections)
: VIDEO IN
: VIDEO OUT
(VCC-4594P only)
Basic connection for monitoring or recording
The peripheral devices (VCR, monitor, lens, etc.) and cables are
sold separately.
1
Make the video signal connection between the camera and
the monitor or time lapse VCR.
2
Connect to 24 V AC UL listed class 2 power supply (sold
separately).
CAUTION:
•
To prevent camera and/or power supply failure, pay close attention
to polarity when making the connections.
•
To prevent fire hazard any UL listed wire rated VW-1, should be used
for the 24 V AC cable input terminal.
9
English
(A)
1
2A
(A)
24 V AC GND 24 V AC
2
2A
(B)
2A:
When using this unit, the supplied clamping core (A or B) must be
installed on the power cord and BNC cable, in order to prevent
electromagnetic interference to the other devices connected.
3
Insert the plug of this power cord into a wall outlet.
The POWER indicator (A) will light. Adjust the picture on the
monitor using the Brightness and Contrast controls.
Coaxial cable type and maximum length
• Cable type RG-59U (3C-2V), 250 m maximum.
• Cable type RG-6U (5C-2V), 500 m maximum.
•
Cable type RG-11U (7C-2V), 600 m maximum.
CAUTION:
•
The RG-59U type cable should not be run through electrical
conduits or through the air.
•
Using CCTV/Video-grade coaxial cable.
2A
(A)
2A
(B)
3