Installation; When Using The Unit On Atabletop; When Using The Unit Witha Mounted Wall; Mounting The Stand - Sharp FU-40SE Operation Manual

INSTALLATION

WHEN USING THE UNIT ON A
TABLETOP

MOUNTING THE STAND

1
Remove the front panel.
• At this time, also remove the pre-filter,
stamina-power carbon and the HEPA
filter.
Front panel
2
Place the unit with its front
side facing down on a flat
and stable surface.
• Place a soft cloth, etc., to prevent
damaging the unit.
3
Insert the tabs on the stand
into the holes on the main
unit and fix the stand using
the included thumbscrews
(2 units).
Tabs
Thumb-
screws
1
2
1
Holes
WHEN USING THE UNIT WITH
A MOUNTED WALL
CAUTION
• When mounting the air purifier to the wall, the
mounted wall will become dirty as time passes.
To prevent this, place a vinyl sheet, etc.,
around the unit.
• A wall side to install is to choose the place to
have the strength done firmly.
• In the case of a wall or concrete wall with little
strength, request installation to a specialist
such as an electric appliance shop, etc.
• Do not install in a location with heavy lamp-
black, such as in a kitchen, etc. The unit sur-
face may crack as a result.
1
Determine the mounting location
Leave space around the bracket by referring
to the illustration below. The unit cannot be
mounted if there is insufficient spacing
around the bracket.
75cm or more
75cm or more
60cm or more from
sidewall
CAUTION
Mount on a flat sur-
face
• Do not mount the unit to
a location that is not flat
such as a wall with a
door header, etc.
Do not mount the unit to
a thin wall with little
strength such as a plas-
terboard, etc. The unit
may fall and can be very
dangerous.
E-6
69cm or more from
the ceiling
Size of main
unit
75cm or more
Mounting
bracket 1
60cm or more
from sidewall