Rudder And Elevator Servos - E-FLITE Eratix 3D 25e Assembly Manual

Rudder and Elevator Servos

Required Parts
• Fuselage
• Long servo arm (2)
• Clevis (2)
• Nylon control horn (2)
• Control horn standoff (2)
• 4-inch (102mm) pushrod wire
• 5 1 -inch (140mm) pushrod wire
/
2
• 12-inch (305mm) servo extension (2)
• Pushrod wire connector (2)
Required Tools and Adhesives
• Phillips screwdriver (small)
• 30-minute epoxy
• String or dental floss
1. Secure a 12-inch (305mm) servo extension to the
 
servo. Mount the elevator servo using the hardware
provided with the servo.
Note: Use string or dental floss to secure the servo lead
to the servo extension so they don't become unplugged
during flight.
E-flite Eratix 3D 25e ARF Assembly Manual
• Servo (2)
• Clevis retainer (2)
• 3mm x 30mm machine screw (2)
• Control horn washer (2)
• Hobby knife
• Threadlock
2. Attach the control horn in position on the rudder
 
and elevator using the same technique as the aileron
control horns.
Note: Use threadlock on the control horn screw to
prevent it from vibrating loose.
25