Required Radio Equipment; Notes Regarding Servos And Esc; Important Information About Motor Selection; Lightweight Sport Setup - E-FLITE Eratix 3D 25e Assembly Manual

Required Radio Equipment

You will need a minimum 6-channel transmitter, receiver, and
four mini servos. You can choose to purchase a complete radio
system that includes all of these items or, if you are using an
existing transmitter, just purchase the other required equipment
separately.
Note: We recommend the crystal-free, interference-free
Spektrum ™ DX7 2.4GHz DSM2
complete system includes standard servos, which are not
required for the Eratix 3D 25e.
Purchase Separately
SPM6070
Or
JRPR720
Or
JRPR790
JSP98030
JRPSDS3421
HRC32225S
Note: When using our recommended E-flite 60A Pro
Brushless ESC with switching BEC you do not need a
separate receiver pack as long as you are using our
recommended servos.
Important Servo Note:
If you plan on flying your Eratix 3D 25e to its full
capabilities, we recommend only metal geared servos.
During 3D flight, the large control surfaces will exhibit
large flight loads on the servos. Plastic geared servos
failed during testing and are not recommended for use.

™ 7-channel radio. The
DSM2 7-Channel Receiver
7-Channel ScanSelect ™ FM Receiver
7-Channel ScanSelect PCM Receiver
12-inch (305mm) Servo Extension (2)
DS3421 Digital MG Mini Servo (4)
HiTec 225MG
JSP98010 JR SPORT
EXRA050 Expert Standard Switch

Notes Regarding Servos and ESC

WARNING: Depending on what speed control you are using,
if it is not capable of supporting four mini-size servos because
of current draw, the speed control may shut down due to high
heat.
Use of servos other than those we recommend may overload the
BEC of the recommended Electronic Speed Control (ESC). We
suggest the use of only the servos we recommend when utilizing
the recommended ESC's BEC, or the use of a separate BEC (like
the UBEC) or receiver battery pack when using other servos.
Important Information About Motor
Selection
The Eratix 3D 25e does not include a propeller. We are
recommending the Power 25 or Power 32 outrunner motors.
The motor systems listed will provide you with excellent
aerobatic power for sport and/or artistic aerobatic pilots.

Lightweight Sport Setup

EFLM4025A Power 25 BL Outrunner, 870Kv
EFLA1060 60A Pro Switching BEC Brushless ESC
THP42003S2PPL 4200mAh 3S2P 11.1V Li-Po, 13GA
APC14070E Electric Propeller, 14x7E
EFLC3005 Celectra
EFLAEC303 EC3 Dev & Batt, Male/Female
This is a very good 3D/Aerobatic setup with
strong performance.
™ 4.8V 700mAh Rx Pack
™ 1- to 3-cell Li-Po Charger
E-flite Eratix 3D 25e ARF Assembly Manual