Aileron Installation - E-FLITE Eratix 3D 25e Assembly Manual

Aileron Installation

Required Parts
• Wing
• Servo w/hardware (2)
• CA hinge (8)
• Clevis (2)
• Nylon control horn (2)
• Control horn standoff (2)
• 2 7 -inch (73mm) pushrod wire (2)
/
8
• Pushrod wire connector (2)
Required Tools and Adhesives
• Rotary tool
• T-pins
• Felt-tipped pen
• Threadlock
• #1 Phillips screwdriver
  1. Locate four CA hinges. Place a T-pin in the center of
each hinge.
1
• Receiver
• Long servo arm (2)
• Clevis retainer (2)
• 3mm x 30mm machine screw (2)
• Control horn washer (2)
• Drill bit: 1/16-inch (1.5mm)
• Thin CA
• Pen drill
• Side cutters
  2. Use a rotary tool and a 1/16-inch (1.5mm) drill bit
to drill a hole in the center of each hinge slot of both the
aileron and wing. This provides a tunnel for the CA to
wick into, penetrating the hinge.
Hint: You can prepare the rudder, fin, elevator and
stabilizer at this time as well.
  3. Slide the four hinges into the slots in the aileron.
E-flite Eratix 3D 25e ARF Assembly Manual