Center Of Gravity - E-FLITE Eratix 3D 25e Assembly Manual

The control throw measurements are taken at the widest
point on the surface.
Low Rate
Ailerons:
Up 1-inch (25mm)
Down 1-inch (25mm)
Elevator:
Up 1-inch (25mm)
Down 1-inch (25mm)
Rudder:
Right 2-inch (51mm)
Left 2-inch (51mm)
These are general guidelines measured from our own
flight tests. You can experiment with higher rates to match
your preferred style of flying.
28
High Rate
3-inch (76mm)
3-inch (76mm)
3 1 -inch (90mm)
/
2
3 1 -inch (90mm)
/
2
4 1 -inch (114mm)
/
2
4 1 -inch (114mm)
/
2

Center of Gravity

An important part of preparing the aircraft for flight is properly
balancing the model.
Caution: Do not inadvertently skip this step!
The recommended Center of Gravity (CG) location for the
Eratix 3D 25e is 3 1 inches (83mm) to 4 inches (102mm) back
/
4
measured from the center of the leading edge of the wing next
to the fuselage.
After your first flights, the Center of Gravity can be adjusted for
personal preference.
E-flite Eratix 3D 25e ARF Assembly Manual