Troubleshooting Guide - Metrologic MS6200 Pulsar Series Installation And User Manual

T G
ROUBLESHOOTING UIDE
The following guide is for reference purposes only. Contact a Metrologic
representative at 1-800-ID-METRO or 1-800-436-3876 to preserve the limited
warranty terms on page 28.
S P
YMPTOMS OSSIBLE
No LEDs, beep No power is being supplied to
or laser line
the scanner
No power is being supplied to
No LEDs, beep
the scanner from host
3 beeps on
Non-volatile RAM failure
power up
Continuous razz
RAM or ROM failure
tone on power up
Razz tone at VLD failure or a Scanner
power up flipper failure
Unit scans,
Same Symbol timeout set too
Communicates
short
and beeps twice
The unit powers
Beeper disabled. No tone
up but does not
selected
beep
14
C ( ) S
AUSE S OLUTION
Check transformer,
outlet and power strip.
Make sure the cable is
plugged into the
scanner.
Some host systems
cannot supply enough
current to power the
MS6220. Use the
proper power supply.
Contact a Metrologic
Representative, if the
unit will not hold the
programmed
configuration.
Contact a Metrologic
Representative.
Contact a Metrologic
Representative.
Adjust same symbol time
out for a longer time.
Enable beeper. Select
tone.