Lexmark X543 series Service Manual page 52

7525xxx
User status and attendance messages (continued)
User primary message Explanation
31.xx Defective <color>
cartridge
31.xx Defective Imaging
Kit.
32.xx Replace
unsupported <color>
Cartridge
34 Short Paper
35 RES Save Off
Deficient Memory
37 Insufficient Collation
Area
2-8
Service Manual
The specified cartridge is defective. Try one of the following:
• Open and close the top cover.
• Remove and re-install the cartridge(s). Listen for the click to ensure the cartridge
is installed properly.
• Turn the printer power off and turn the printer power on.
If the message persists, replace the cartridge with a new one, and close the front
cover.
Defective imaging kit. Try one or more of the following:
• Open and close the top cover.
• Remove and re-install the cartridge(s). Listen for the click to ensure the cartridge
is installed properly.
• Turn the printer power off, and then turn the printer power on.
If the message persists, determine if the imaging kit counter is greater than 15,000
cycles. It it is, then replace the entire kit. See
page 4-28. If the counter is below 250,000 cycles, replace only the photoconductors.
Remove the specified cartridge, replace with a supported cartridge, and close the
front cover.
)
• press Select ( to clear the message and continue printing.
The printer does not automatically reprint the page that prompted the message.
• Check tray length and width guides to ensure paper is properly fitted in the tray.
• Make sure the print job is requesting the correct size of paper.
• Adjust the Paper Size setting for the size paper you are using.
If MP Feeder Size is set to Universal, make sure the paper is large enough for the
formatted data.
• Cancel the current job.
This message displays when the printer lacks sufficient memory to enable Resource
Save. This message usually indicates the user has allocated too much memory for
one or more of the printer link buffers; however, modification of other printer settings
which affect the amount of available memory may also create this condition. If
restoration of Resource Save is required after this message is received, the customer
should install additional memory or set each link buffer to Auto. Once all link buffers
are returned to Auto, you should exit the menu to activate the link buffer changes.
Once the printer returns to the Ready state, you can enable Resource Save and go
back and modify the link buffers again. Note the reduction of available memory to the
link buffers when Resource Save has been enabled, and compare it to the memory
available when Resource Save is disabled.
• press Select ( ) to disable Resource Save and continue printing.
To enable Resource Save after you get this message:
- Make sure the link buffers are set to Auto, then exit the menus to activate the
link buffer changes.
- When Ready is displayed, enable Resource Save.
• Install additional memory.
This message is displayed when the printer memory used to store pages is too full to
collate the print job.
The following actions can be taken:
• press Select ( ) to print the portion of the job already stored, and begin collating
the rest of the job.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions are available.
- Cancel Job
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
Lexmark confidential until announce
"Imaging unit (IU) removal" on