Font Sharpening; Pel Blurring; Exit Config Menu - Lexmark X543 series Service Manual

Lexmark confidential until announce

Font Sharpening

This setting is used to set a text point size value below which the high frequency screens will be used when
printing data. This setting affects only PCL, PostScript and PDF emulators.
Settings are in the range of 0–150 (24 is the default). For example, if the value is set to 24, then all fonts sized 24
points or less use the high frequency screens.
To adjust the Font Sharpening setting, perform the following steps:
1.
In the configuration menu, scroll to the Font Sharpening menu item and press
2.
Use the
pressing
3.
press

Pel Blurring

The Pel Blurring setting is used if step artifacts are noticed by the customer on copies and scans. When set to
On, Pel Blurring smooths out the artifacts to produce a higher quality image.
To change the setting, perform the following steps:
1.
In the Configuration menu, use the arrow keys to scroll to the Pel Blurring menu item.
2.
press
3.
press
4.
press
5.
press to exit the Pel Blurring menu item.
6.
Scroll to Exit Config menu.
7.
press

Exit Config Menu

With the Exit Config menu item displayed, press Select (
a power-on reset and returns to normal mode.
or to increase or decrease the settings value. pressing
increases the value.
to accept the setting.
.
or to select the desired setting.
to accept the change.
. The device restarts.
decreases the value and
) to exit the Configuration Menu. The printer performs
7525xxx
.
3-37
Diagnostic aids