Toshiba TRST-A10 SERIES Quick Installation Manual page 5

4. Receipt Roll
Paper type
Width (W1)
Width (W2)
Outer diameter (D)
Paper thickness (T)
Weight
Outer core diameter
Inner core diameter
Recommended thermal
paper
CAUTION!
Use only paper which meets specified requirements. Use of non-specified paper may
shorten the head life of the printer, resulting in problems with print quality, cause a paper
feed failure or shorten the cutter life. All paper should be handled with care to avoid any
damage to the paper. Read the following guideline carefully.
•
Do not store the paper for longer than the manufacturer's recommended shelf life.
•
Store the paper in a cool, dry place. Avoid areas where they would be exposed to direct
sunlight, high temperature, high humidity, dust or gas.
•
A contact of chemical or oil may discolor or erase the printed record.
•
Rubbing the paper hard with nail or hard object may discolor the paper.
•
The paper end should not be pasted to the core.
For further information please contact your authorized TOSHIBA TEC representative or
authorized paper manufacturer.
Thermal paper rolled with the print side facing outside
80 +/ -1.0 mm
58 +0/ -1.0 mm (With optional 58 mm paper guide)
76 +/-2.0 mm
0.065 +/- 0.005 mm
2
53 g/m
21.5 mm
12.5 +/- 0.5 mm
Only paper rolled onto a core is acceptable, however, the
paper end should not be pasted to the core. TOSHIBA
TEC recommends using the following thermal paper for
this product.
Manufacturer : OJI
Type : JFD210
5
W1 or W2