Lexmark Optra SC 1275 Service Manual page 55

Attendance Message
8X Scheduled Maintenance
82 Waste Toner Bottle Missing
82 Waste Toner Bottle Full
2-20
Action
The following messages appear to
alert you that certain assemblies
need replacing:
80 - Fuser Assembly and Second
Transfer Roll Assembly
81 - Transfer Belt Assembly
Press Go to clear the message.
The status of the two maintenance
items listed above will be displayed
in the User Maint Menu. The User
Maint Menu will be active only if one
or both maintenance items have
expired. Once the items have
expired, they should be replaced as
soon as possible. After you have
replaced the expired items, you must
reset the appropriate maintenance
message.
The waste toner bottle is not
installed or there is a problem with
the toner collecting box detection
switch (S6). Open the top door,
install the waste toner bottle, and
close the top door.
The message clears from the display
when the top door is closed. If it
does not, go to the "Sensor Service
Check" on page 2-47.
Open the top door, remove the full
waste toner bottle. Replace the
waste toner bottle and close the top
door. The customer replaces this
part at prescribed intervals.
The message clears from the display
when the top door is closed. If it
does not, the toner full sensor (PC6)
could be failing. Go to the "Sensor
Service Check" on page 2-47.