After Mowing/Storage - Qualcast CEM 30 Operating Instructions Manual

Remove pulley 32 and belt 26 by removing
3 screws 27.
Pull the cutting cartridge unit 25 out using the
handle. Obtain assistance if required.
Replace the cartridge and
screws 24.
Slacken the idler pulley screw 34.
Refit the pulley 32 and belt 26.
Adjust the idler pulley 33 against the belt 26 and
tighten idler pulley screw 34.
Refit the drive cover 28.
This method is the same for fitting or removing
cartridge accessories.

After Mowing/Storage

Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and de-
bris, especially from the ventilation slots
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted in
the blade area, remove with a wooden or plas-
tic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine. To save
space, fold up the handle fully.
Ensure cables are not trapped when folding/
unfolding top handle, do not drop the handle.
F016J10011A page 9
Product, accessories and packaging should be
sorted for environment-friendly recycling.
fit retaining
Only for EC countries:
law, power tools that are no longer suitable for
use must be separately collected and sent for
recovery in an environmentally-friendly man-
ner.
8.
5
Disposal
Do not dispose of power tools into
household waste!
According to the European Direc-
tive 2002/96/EC on waste electri-
cal and electronic equipment
and its incorporation into national