Qualcast CEM 30 Operating Instructions Manual page 7

It is recommended for increased electrical
safety to use a Residual Current Device (RCD)
with a tripping current of not more than 30 mA.
Always check your RCD every time you use it.
If you want to use an extension cable when op-
erating your product, only the following cable
dimensions should be used:
2
- 1.0 mm max length 40 m
2
- 1.5 mm max length 60 m
2
- 2.5 mm max length 100 m
Note: If an extension cable is used it must be
earthed and connected through the plug to
the cable of your supply network in accord-
ance with prescribed safety regulations.
For products not sold in GB:
WARNING: For safety, it is essential that the
mains plug 7 attached to the product is fitted to
the power supply cable 35.
The couplings of connection leads must be pro-
tected against splashes and the coupling sock-
ets on the leads must be made of rubber or
coated with rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for
signs of damage at regular intervals and may
only be used if in perfect condition.
If the supply cord is damaged, it must be re-
placed by an approved Service Centre.
Products sold in GB only:
with an approved 13 A (BS 1363/A) electric plug
and is protected by a 13 A fuse (ASTA Ap-
proved to BS 1362).
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place by an authorized cus-
tomer service agent.
The severed plug must be disposed of to avoid
a possible shock hazard and should never be in-
serted into a 13 A socket elsewhere.
Assembly
Unfold the top handle 1 and tighten wing-
A
nut.
Note: Ensure that the cable clips supplied are
used to fix the cable to the handle.
The blades will require adjustment – see "Adjust-
ing Blades".
Attach cable to cable restraint
sufficient cable slack is available. (Euro models
only)
F016J10011A page 7
B
Spring
holes 12.
Attach/remove the grassbox as shown.
B
Your machine has six settings which give the fol-
lowing approximate height of cut:
1 = 9 mm
4 = 25 mm
Position "S" should only be used with the Scari-
fier Cartridge accessory (purchased separately).
To adjust the height of cut:
Tilt the mower to take the weight off the front
roller.
Push the height of cut knob 10 in and turn to the
desired position.
For the first cutting of the season, a high cutting
adjustment should be selected.
Your mower is fitted
6 ensuring that
3
Grassbox
the grassbox cradle 11 into
Height of cut adjustment
2 = 13 mm 3 = 18 mm
5 = 32 mm S = Scarifier
pivot