Yamaha F80B Service Manual page 197

Recommended power trim and tilt
fluid:
ATF Dexron II
5. Install a new O-ring, the joint, and the
power trim and tilt motor 5 by installing
the bolts, then tightening them to the
specified torque.
5
PTT motor bolt:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
6. Add fluid of the recommended type to the
first level at the bottom of the trim cylin-
der.
7. Install the balls 6 into the tilt cylinder,
and then insert the tilt cylinder into the
trim cylinder 7.
6D93G11
S6D87450
NOTE:
Apply grease to the balls from falling out of
the cylinder installation.
8. Install the trim cylinder end screw 8, and
then tighten it to the specified torque.
9. Fully extend the tilt rod, and then add suf-
S6D87460
ficient fluid of the recommended type to
the correct level.
Tilt cylinder and trim cylinder
Cylinder-end screw wrench:
New: 90890-06568
Current: 90890-06544
Trim cylinder end screw 8:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
1
2
3
4
8
5
S6D87660
6
7
8
9
7-42