Nilfisk-Advance SC1500 Troubleshooting

ATTENTION!
Do not use the machine before you have read and understood the User Manual
1. Check the battery charge gauge 2. F ill-in the tank with clean water.
(and if necessary re-charge) .
6. Check if the solution filter is clean 7. Stand on the machine and turn on
11. Select double pressure if needed 12. Select silent mode if needed
16. Remove and clean the debris tray 17. Wash the recovery tank with clean
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
3. C heck the vacuum hose is
Check if the Ecoflex bottle is well connected to the squeegee
installed (only for machine with
Ecoflex)
8. Press the One-Touch button
the key (squeegee lowers automati-
cally)
13. P ress the forward pedal, select the
18. Remove debris from the brushes
water
OPERATING GUIDELINES
SC1500
4. Check the brush is clean
9. Adjust to the desired water flow
14. Open the crew cap and empty the
direction and start operating the recovery tank with the squeezable
machine hose
19. Take the squeegee off and check
the blades' wear status
5. Install the brush on the deck
10. A djust to the desired chemical
concentration
15. If necessary, empty the solution
tank through the solution valve and
clean the filter net
20. Clean the machine using a damp
cloth and park it with the recovery
tank open