Call Procedure - Icom iC-F30GT Instruction Manual

' ' Call procedure

When your system employs tone signalling
, the call procedure may be necessary prior to voice trans-
DTCS)
mission. The tone signalling employed may be a selective calling
system which allows you to call specific station(s) only and prevent
unwanted stations from contacting you.
q Select the desired Tx code channel or 5-tone code according to
your System Operator's instructions.
• This may not be necessary depending on programming.
• Refer to the next page for selection.
w Push the call switch (assigned to one of the dealer programma-
ble switches: [P
e After transmitting a 5-tone code, the remainder of your commu-
nication can be carried out in the normal fashion.
Selective calling
], [P ], [P ], [P
0 1 2
CONVENTIONAL OPERATION
(excluding CTCSS and
], [F2] and [F3]).
3
Non-selective calling
5
17