Manage The Wifi Settings And Wifi Security Of The Guest Network; Set Up And Enable A Guest Network - NETGEAR D3600? D6000 User Manual

10. Within four minutes, go to the WiFi device and use its WPS software to join the network
without entering a password.
When the modem router establishes a WPS connection, the WPS LED lights solid green
again and the Add WPS Client screen displays a confirmation message.
11. To verify that the WiFi device is connected to the modem router's main WiFi network, select
BASIC > Attached Device.
The WiFi device displays onscreen.
Manage the WiFi Settings and WiFi Security of the Guest
Network
A guest network allows visitors to use the Internet without using your WiFi security key. By
default, the guest WiFi network is disabled. You can enable and configure the guest WiFi
network for each WiFi band. The modem router simultaneously supports the 2.4 GHz band
for 802.11n, 802.11g, and 802.11b devices and the 5 GHz band for 802.11na and 802.11a
devices and, for the AC750 WiFi DSL Modem Router Model D6000, also 802.11ac devices.
The WiFi mode of the guest WiFi network depends on the WiFi mode of the main WiFi
network. For example, if you configure the WiFi mode for the main WiFi network as Up to
54 Mbps in the 2.4 GHz band, the guest WiFi network also functions in the Up to 54 Mbps
mode in the 2.4 GHz band. For information about configuring the WiFi mode, see
the Basic WiFi Settings and WiFi Security of the Main Network

Set Up and Enable a Guest Network

The modem router provides the following default guest networks:
• 2.4 GHz band:
- NETGEAR-Guest
- NETGEAR-Guest2
- NETGEAR-Guest3
• 5 GHz band:
- NETGEAR-5G-Guest
- NETGEAR-5G-Guest2
- NETGEAR-5G-Guest3
By default, all of these networks are configured as open networks without security but are
disabled. You can enable one, several, or all networks. You can also change the names
(SSIDs) for these networks.
N600 and AC750 WiFi DSL Modem Routers
Manage the WiFi Network Settings
67
Manage
on page 56.