VADDIO WALLVIEW PRO Z700 WITH HSDS Installation And User Manual

Camera and Electronic Products for Integrators
W VIEW™ PRO Z700
ALL
Vaddio™ PRO Series Cable System with High
Speed Differential Signaling for the Sony®
BRC-Z700 High Definition PTZ Camera
OVERVIEW
The Vaddio WallVIEW PRO Z700 (Figure 1) is built
around the Sony BRC-Z700 high definition PTZ Camera
with three ¼-type CMOS 1.1 megapixel image sensors.
The WallVIEW PRO Z700 uses high speed differential
signaling (HSDS), an active transmission system to
deliver superior video quality over Cat. 5 cabling
distances up to 500 feet.
The WallVIEW PRO Z700 system is capable of 1080i
HD 16:9 resolution in NTSC or PAL. Simultaneous SD
video out (crop, squeeze or letterbox) is available
simultaneously but requires an additional Cat. 5 cable
and two Vaddio Quick-Connect boxes.
The WallVIEW PRO system also has many new features, including a unique IR forwarding system which
allows the user to forward IR commands from third party IR remote controls, through the WallVIEW system to
a third party device. In addition the system also has auto camera resolution sensing, analog component
video outputs (Y,Pb, Pr), four position distance adjustment for Cat. 5 cabling, Y-Gain adjustment, 1-RU rack
mount Quick-Connect™ PRO System with HSDS, and the EZ Interface Module (EZIM) that fastens to the
back of the camera mount. Like all Vaddio WallVIEW systems, the Thin Profile Wall Mount and mounting
hardware is included.
INTENDED USE
Before installing the Vaddio WallVIEW PRO Z700 Camera System, please read the entire manual thoroughly.
All Vaddio camera systems were designed for use indoors. Outdoor operation is not recommended, has not
been tested, and could damage the camera and/or create a potentially unsafe operating condition. Use only
the Vaddio PowerRite power supply provided.
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you install the Vaddio WallVIEW PRO systems. For
reference, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product
drawings for the Vaddio product line on the website.
www.vaddio.com free of charge.
IMPORTANT SAFEGUARDS
Read and understand all instructions before using. Do not operate any electrical device if it has been
dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To
reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid
conditions.
Use only the power supply provided with the Vaddio WallVIEW products.
Use of any unauthorized power supply will void any and all warranties.
INFORMATION
For RS-232 control information, please see the full-length Technical Manual for the SONY BRC-Z700 model.
This manual can be found either on the Vaddio or Sony website. Vaddio has also prepared a number of
TechNotes, specifications and drawings designed to inform and educate integrators on the value and the
specific uses of Vaddio products.
©2008 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing subject to change. Vaddio,
WallVIEW, EZIM, HSDS, Quick-Connect, and PowerRite are registered trademarks of Vaddio, Inc. All other trademarks are property of their respective owners.
Document Number 341-674 Rev. B
Installation and User Guide
HSDS™
WITH
Figure 1:
WallVIEW PRO Z700 System with Camera,
Wall Mount and EZIM (behind camera)
These documents can be downloaded from