Record - Lorex LH314 SERIES Instruction Manual

• NTSC/PAL Select: Scroll up/down to select
NTSC (I.e. North America), PAL (i.e. Europe),
or AUTO. If AUTO, the system will
automatically detect the format of the
connected cameras.
• Date/Time Setup: Click to open Date/Time
Setup. See "Setting the Date and Time" on
page 9.
• DVR Password: Click to open the password
menu. See "Managing Passwords" on
page 17.
• Information: Click to view system information:
software, hardware, disk, and LAN.
3. To save your settings, right-click or click
until you return to the main screen.
Figure 11.2 System information

Record

Set recording parameters, image quality,
resolution, set the recording schedule, and
format the hard drive.
Figure 12.0 Record menu
NOTE: As you make changes to the recording
parameters, the storage calculator at the bottom
of the menu displays the time remaining on the
hard drive.
To configure record settings:
1. From the Main Menu, click
Record menu opens.
2. Configure the following FPS (frames per
second):
/Motion Rate: Click under each
• Alarm
camera and select X, 2, 3, 5, 7.5, 10, or
15 (fps).
• Working Hour Rate: Click under each
camera and select 0, 2, 3, 5, 7.5, 10, or
15 (fps).
• Non-working Hour Rate: Click under
each camera and select 0, 2, 3, 5, 7.5, 10,
or 15 (fps).
Figure 12.1 Frame rates for NTSC and PAL
• Quality: Click under each camera and
select 1, 2, 3, 4, or 5.
Figure 12.2 Set image quality: 1 basic ~ 5 excellent
• Audio: Click under each camera and
select either O to enable audio or
disable audio.
NOTE: Audio is only available on
channels 1 and 2.
• Resolution: Click to set the resolution for
all cameras—640x240 or 640x480.
Using the Main Menu
. The
X to
21