Q: How Do I Set Up The Dvr To Record Only When There Is Motion Detected - Lorex LH110 series Faq

3 Power on the monitor.
4 Power on the DVR. Wait for it to boot into the main window.
NOTE: After you re-connect the VGA cable between the monitor and DVR, ensure that you
first turn on the monitor, and then turn on the DVR. This allows the DVR to auto-detect
the connected VGA monitor.
NOTE: If you still cannot see the mouse cursor or access the menu, press the 0 (zero) button
on the remote control.
Manually setting the DVR output mode
You can set the DVR to always output to the VGA port by manually configuring the output
settings.
To manually adjust the output
settings:
1 Right-click and click Main
Menu.
2 Click Advanced>A/V Setup.
3 In the Output Device drop-down
menu, select VGA.
NOTE: In the 16-channel model,
select VGA in the Init DEV
drop-down menu.
4 Click Apply to save your
settings.
Q: How do I set up the DVR to record only when there is motion
detected?
A: To set up the DVR to record only when motion is detected, you will need to configure a
recording schedule that will record events only (events include motion, video loss from a
camera, hard drive loss, or hard drive nearing capacity), copy the schedule to all channels,
and configure your cameras for motion detection.
To configure an event-only recording schedule:
1 Right-click and select Main Menu.
2 Click Record.

Copyright 2013 Lorex Technology
4/8 Channel
16 Channel
www.lorextechnology.com
Select VGA
Select VGA
3