Table of Contents
Advertisement
2. Preparation for use
The preparation for use of these devices must be performed by
qualified personnel both for evaluate the suitability of the product and
to provide the correct instructions to the user.
2.1 Handbike preparation
The handbike is shipped with the rear wheels not
assembled.
Mount the rear wheels, screwing and fixing properly the
wheel axle.
2.2 Pneumatic pressure check
A periodical check of the pneumatic pressure may helps to keep the handbike
efficient and more comfortable.
Verify the tire pressure value according to the value marked on the tyre.
Normally 7.5 BAR is the right value for high pressure tyres.
The above value is indicative as the specific value is always available on every
tyre.
2.3 Checking the brakes
To check the functioning and the efficiency of the parking brakes act as following:
Activate the brake
Check if the wheels are blocked.
If necessary you can act on the wire
adjustment device to set-up the proper
brake power.
2.4 Checking the accessories
Any accessory required at the time of the configuration of the handbike may be
6
Advertisement
Table of Contents
