Advertisement
2. WHEELCHAIR PREPARATION
HOW TO PREPARE THE WHEELCHAIR BEFORE USE
The wheelchair is shipped inside a carton box complete with wheels and other accessories.
The wheelchair can be open acting a pressure with the hand palm on the seat paying attention
to the hand fingers.
Only for Europa wheelchair: it is recommended to perform a quick check if the rear wheels are
properly inserted on the frame.
To verify if the wheels are correctly hooked, check if the button is no longer depressed trying to
pullout the wheels without pressing the axle's button.
Check the tyre pressure if they are pneumatic.
A wrong tyre pressure can compromise the brakes efficiency.
Check also the efficiency of the brakes before using the device.
The brake must be used only for parking, never use them as service brakes.
Assemble the foot-rest to the frame checking the good functioning of the blocking mechanism.
If the wheelchair is ordered with options supplied separately, they must be assembled before
the use.
If the wheelchair needs further adjustments to better fullfil the user's requirements,
contact your dealer or other qualified person.
3. ADJUSTMENTS
3.1. SEAT HEIGHT AND REAR SET-UP
For Mizar wheelchair is possible only to change the seat/floor height, changing the front and
rear wheel size.
For Europa wheelchair instead it is possible to change the front and rear seat/floor height and
the depth of the rear wheels acting as follows:
Rear height seat/floor adjustment and rear wheel depth adjustment
Pullout the wheel pressing the axle's button.
Change the position of the rear wheel plate as requested.
Insert again the wheel pressing the axle's button.
Front height seat/floor adjustment
The front seat/floor height can be changed acting on the size of the front castors or changing
the castor position on the fork.
Once the seat tilt has been changed, the front fork plate holders need to be adjusted to be
perpendicular to the ground. To perform this operation, act as follows:
4 4
Advertisement
