Maintenance - Lanzar SD34MIP Owner's Manual

Before You Start

Maintenance

Replacing the Fuse
Make sure the amperage matches the
specified value when replacing the fu-
ses. If the fuse is blown, check the po-
wer connection and replace with a n-
ew one. If the same problem occurs,
it would be subjected to the malfun-
ction. In such cases, please consult
to the nearest service dealer.
Warning
!
Never use the fuse with the rated
amperage more than that supplied to
your unit, otherwise it will damage the
unit.
Replacing the Battery
When the range of the operation of the
card remote control becomes short or no
functions while operating. Replace the
lithium battery with a new button cell
(CR2025). Make sure the battery polarity
before replace.
Gently pull out the Battery Holder while
pressing the Stopper.
Put the button-type battery with mark(+)
upward into the Battery Holder.
6
Insert the Battery Holder into the Remote
Control.
Precautions on Using Lithium
Battery
Always keep the lithium battery beyond
children s reach. In case
swallowed, see a doctor immediately.
Cleaning the battery with a dry cloth,
to ensure its perfect connected.
Make sure the proper polarity when
loading with the battery.
To prevent short circuit, do not use
metal tweezer to clip the battery.
! Warning
Improperhandle with the batter may
lead to explosion.
It cannot be charged, disassembled
or thrown into a fire.
Tuner
Scanning/Memorizing Stations
Automatically
During radio status, you can press AMS
4
button on the remote control to scan each
stored station 5 seconds respectively which
stored in Number Buttons (from 1 to 6).
24
You can press the corresponding Number
Buttons or AMS button when your desired
station is charged. And it starts playing that
station.
When press and hold 4 button it will ,
AMS
activate automatically memory storing fun-
ction. The radio automatically selects a
station and has it stored in any one of the
Number Buttons from 1 to 6.
Notes:
Press AMS on the head unit also performs
*
the same function.
The unit can be stored up to 6 stations for
*
each band.
Regarding the function of Number Buttons,
*
refer to Number Buttons for more inform-
ation.
Number Buttons
During radio mode,
Number Buttons
from 1 to 6 can help you store your
24
favorite station. You can follow the steps
as below:
When receiving a station, press and hold
any one of the Number Buttons until
CH i
(i=1~6) appears on the LCD, which in-
dicates that station is already stored in the
corresponding number button.
You can store up to 18 FM stations 6 each (
for FM1,FM2,FM3),up to 12AM stations
(6 each for AM1/MW and AM2/LW).
Note:
* This function is only operated by using rem-
ote control.
08
Selecting Station Directly
Press 2 GOTO button, the monitor shows:
FR:, input the number to receive the station
of this frequencies.
Note:
* This function is only operated by using rem-
ote control.
39