Removing And Reinstalling The Front Bezel - Lenovo ThinkServer TS130 User Manual

CAUTION:
Turn off the server and wait three to five minutes to let the server cool before removing the server
cover.
To remove the server cover, do the following:
1. Remove any media from the drives and turn off all attached devices and the server.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output (I/O) cables, and any other cables that are connected to the
server. See "Front view" on page 11 and "Rear view" on page 12.
4. Remove any locking device that secures the server cover, such as a padlock or an integrated cable lock.
See "Integrated cable lock" on page 53and "Padlock" on page 53.
5. Remove the two thumbscrews that secure the server cover.
6. Press the cover-release button on the side of the server and slide the cover to the rear of the server
to remove the cover.
Figure 8. Removing the server cover

Removing and reinstalling the front bezel

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 17.
This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel, do the following:
20
ThinkServer TS130 User Guide