Lenovo ThinkServer TS130 User Manual page 46

5. Press the release button
out of the chassis.
Figure 24. Removing the secondary hard disk drive
6. Pull on the blue handle to release and remove the hard disk drive from the hard disk drive cage.
7. Flex the sides of the blue bracket to remove the hard disk drive from the bracket.
8. To install the secondary hard disk drive, flex the sides of the bracket properly and align pin
3 , and pin 4 on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board 5 on the bottom of the hard disk drive.
Note: If you are installing a 2.5-inch hard disk drive, install the hard disk drive into a 2.5-inch to 3.5-inch
hard disk drive tray first and then install the tray into the blue bracket.
Figure 25. Installing the hard disk drive into the bracket
34
ThinkServer TS130 User Guide
1 to release the hard disk drive cage and then lift the hard disk drive cage
1 , pin 2 , pin