84
R E P A I R S
Replacing NTC temperature sensor
39
•
Unplug NTC sensor cable from electric control board (42) first.
•
Test NTC temperature sensor (39), see "Replacing thermoblock with NTC sensor
and fine wire fuse(s)" on page 83.
Assembly checkpoint - NTC temperature sensor
•
Tighten the new NTC temperature sensor (39) and spring ring with a torque wrench
(80 - 100 Ncm).
Replacing fine wire fuse(s) (not available separately)
b
a
Assembly checkpoints - fine wire fuse(s)
•
When mounting a safety clip (a) on the thermoblock (15), make sure that the housing
of the fine wire fuse (b) is positioned exactly below the safety clip.
•
Tighten fastening screw and spring ring with a torque wrench (150 (+30/-0) Ncm).
Citiz service manual
15