Table of Contents
Advertisement
VI Appendix
1 Technical information
Operating altitude:
Max. displayed depth: 120 m (395 ft), resolution between 0.8 m and 99.9 m: 0.1 m, >99.9 m: 1 m.
Maximum environment
pressure:
Clock:
Operating temperature: -10°C to +50°C (14°F to 122°F).
Power supply:
Life of the battery:
2 Maintenance
Aladin
is virtually maintenance free. All you need to do is to rinse it carefully with fresh water after each
®
use and to have the batteries changed when needed ->17. To avoid possible problems with your Aladin
the following recommendations will help assure that it will give you years of trouble free service:
WARNING
2.1 Replacing the battery (Battery kit 06.201.919 includes battery and Teflon coated o-ring)
WARNING
VI UWATEC
Aladin
GAUGE
®
®
unlimited
The resolution in feet is always 1 foot.
13 bar (189 psi)
Quartz clock, time, date, dive time display up to 199 minutes.
CR2450, recommended brands: PANASONIC, DURACELL, RENATA,
ENERGIZER, SONY, VARTA.
2-3 years or 200-300 dives. Actual life of the battery depends on the quantity
of dives per year, the use of the backlight and the length of the dives. In cold
water the life of the battery is reduced. Not all CR2450 batteries are the same,
and low quality batteries can have very short life.
• Avoid dropping or jarring your Aladin
• Do not allow your Aladin
• Rinse your Aladin
thoroughly with fresh water after each dive.
®
• Do not store your Aladin
ventilation.
• If there are problems with the water contacts, use soapy water to clean
Aladin
and dry it thoroughly. The surface of your Aladin
®
treated with silicone grease. Do not apply grease to the water contacts!
• Do not clean Aladin
®
• Check the battery capacity before each dive ->7.
• If the battery icon appears, replace the battery ->17.
• Diving with a weak battery: Aladin
vice icon and error code "E3" or "E6" appear. Close the dive and replace the
battery ->17.
• On the surface: if service icon and error code "E3" appear, replace the battery
->17.
All error codes other than E3: Aladin
Take your dive instrument to an authorized SCUBAPRO UWATEC dealer.
Removing the battery clears the no-fly time.
Change the battery only under these conditions:
After a dive if you know you will not be diving or flying for the next 48 hours.
The change must be made with particular care in order to prevent water
from seeping in. The warranty does not cover damages due to an improper
replacement of the battery.
.
®
to be exposed to direct, intense sunlight.
®
in a sealed container; make sure there is free
®
with liquids containing solvent (apart from water).
may stop working during the dive, ser-
®
must not be used for any further dives.
®
VI
,
®
housing can be
®
17
Advertisement
Table of Contents
