Technical Data; Troubleshooting - BRAX MATRIX X4 Instruction Manual

TECHNICAL DATA

Continous power rating at 4 Ohms per channel ...... 4 x 280 Watts RMS ................................... Impedance setting: 4 Ohms
Continous power rating at 2 Ohms per channel ...... 4 x 280 Watts RMS ................................... Impedance setting: 2 Ohms
Continous power rating at 1 Ohm per channel ....... 4 x 280 Watts RMS ................................... Impedance setting: 1 Ohm
Continous power rating, bridged at 4 Ohms ............ 2 x 560 Watts RMS ................................... Impedance setting: 2 Ohms
Continous power rating, bridged at 2 Ohms ............ 2 x 560 Watts RMS ................................... Impedance setting: 1 Ohm
Frequency response...................................10Hz - 80 kHz
Total harmonic distortion (THD).........................< 0,001%
TIM.....................................................................< 0,006%
Signal to noise ratio............................................> 110 dB
Dimensions (H x B x T) in mm...................74 x 330 x 330
TROUBLE-SHOOTING
The BRAX Matrix X4 is in protection mode and the respective LED lights up yellow.
Cause: The speaker wiring is faulty (short circuit between the wires or to the chassis of the vehicle).
Remedy: Check the speaker wires or the speakers themselves for short-circuiting (p.8-9).
Cause: The impedance setting does not correspond to the impedance of the installed loudspeakers.
Remedy: Check the impedance setting (p.10).
For further support concerning matters of trouble-shooting, please visit our website:
www.audiotec-fischer.com/trouble-shooting.html
22
Damping factor..........................................................>800
Input impedance.................................................10 kOhm
Input sensitivity..........................................600 mV - 8,0 V
External fuse............................................................130 A
Weight net...............................................................8,5 kg